Back to Contents Page
|
Microprocessor | |
Video |
|
Expansion Bus | |
Power |
|
Memory | |
Physical |
|
Drives | |
Environmental |
|
Ports |
Microprocessor |
|
|---|---|
| Microprocessor types | Dual
Intel® Pentium® III Xeon™ microprocessors with a minimum internal operating
frequency of 600 MHz |
| Front side bus | 133
MHz |
| Internal cache | internal
to microprocessor |
| Math coprocessor | internal
to microprocessor |
Expansion Bus |
|
|---|---|
| Bus type | PCI
bus |
| Expansion slots | seven
full-length dedicated PCI PCI7 for use with optional DRAC 2 card |
Memory |
|
|---|---|
| DIMM sockets |
72-bit wide 168-pin sockets |
| DIMM capacities | 64-,
128-, 256-, or 512 MB registered SDRAM DIMMs; must be rated for 133-MHz operation and
installed in equal pairs |
| Standard RAM (minimum) |
128 MB |
| Maximum RAM |
4 GB |
Drives |
|
|---|---|
| Diskette drive |
3.5-inch, 1.44-MB diskette drive included with standard system |
| Tape drive |
20 GB and higher |
| SCSI hard-disk drives |
formatted capacities ranging from 9 GB to 36 GB |
| SCSI devices | an
internal SCSI backplane provides a physical connection, hot-plug capability with RAID
controller, termination, and automatic configuration for the internal SCSI hard-disk
drives; an integrated Adaptec Ultra 160/m AIC-7899 SCSI host adapter supporting up to ten
SCSI hard-disk drives depending on the installed backplane integrated Adaptec AIC-7880 Ultra/Wide SCSI host adapter supporting up to three SCSI devices in externally accessible front bays implemented as Ultra/Narrow |
| CD-ROM drive | SCSI CD-ROM drive included with standard system |
Ports |
|
|---|---|
| Externally accessible: |
|
|
two
9-pin connectors |
|
25-pin connector |
|
two 4-pin connectors |
|
RJ45
connector for connection to internal embedded NIC (Intel 82559 10/100 Ethernet controller) |
|
15-pin connector |
|
6-pin mini-DIN |
|
6-pin mini-DIN |
| Internally accessible: |
|
|
two 68-pin connectors for internal or external SCSI drives |
|
50-pin connector for internal CD-ROM or optional tape backup units |
|
34-pin connector for internal 3.5-inch diskette drive |
|
connected to external RJ45 connector |
|
Intel i960® RM on system board; provides PCI-to-PCI bridge; two integrated SCSI channels reside on the secondary PCI bus; optional software and unbuffered, 64-MB or 128-MB SDRAM DIMM available; supports RAID 0, 1, 5, and 10 |
Video |
|
|---|---|
| Video type |
ATI Rage IIC PCI video controller; VGA connector |
| Video memory (standard) | 4 MB
SDRAM |
Power |
|
|---|---|
| AC power supply: |
|
|
320 W per supply |
| Voltage | 100
to 240 V at 60 Hz/230 V at 50 Hz |
| System battery | CR2032
3-V lithium coin cell |
Physical |
|
|---|---|
| Rack
Mount (7U): |
|
|
30.5 cm (12
inches) |
|
44 cm (17.5
inches) |
|
71.1 cm (28
inches) |
|
52.2 kg (115 lb) |
| Tower
Chassis: |
|
|
44 cm (17.5
inches) |
|
30.5 cm (12
inches) |
|
71.1 cm (28
inches) |
|
52.2 kg (115 lb) |
Environmental |
|
|---|---|
| Temperature: |
|
|
10°
to 35°C (50° to 95°F) |
|
–40°
to 65°C (–40° to 149°F) |
| Relative humidity: |
|
|
8% to
80% (noncondensing) with a humidity gradation of 10% per hour |
|
5% to
95% (noncondensing) |
| Maximum vibration: |
|
|
0.25
G (half-sine wave) at a sweep of 3 to 200 Hz for 15 minutes |
|
0.5 G
at 3 to 200 Hz for 15 minutes |
| Maximum shock: |
|
|
six
consecutively executed shock pulses in the positive and negative x, y, and z axes (one
pulse on each side of the system) of 41 G for up to 2 ms |
|
six
consecutively executed shock pulses in the positive and negative x, y, and z axes (one
pulse on each side of the system) of 71 G for 2 ms |
| Altitude: |
|
|
–16
to 3048 m (–50 to 10,000 ft) |
|
–16
to 10,600 m (–50 to 35,000 ft) |
 |
NOTE: For the full name of an abbreviation or acronym used in this table, see the "Glossary." |